► To remove the modulation for a parameter, right-click its outer ring.
→ The dash in the outer ring turns back to the usual indicator for unmodulated parameters.
6.3.1.2 Recording Modulation using the Controller
To modulate a parameter from your controller:
1. Check that the CONTROL button is lit — if not, press it to enter Control mode.
2. Press PLAY to start the sequencer.
3. Press NAV, and then the relevant pad to select the Plug-in slot containing the effect you
want to modulate.
4. Press the Left/Right Arrow buttons to put the focus on the parameter you want to modu-
late.
5. Press and hold SHIFT, and turn the Control encoder.
→ Your modulation gets recorded now. On the next loop, the parameter changes will be re-
produced.
There is also another way to record modulation from your controller: the step sequencer. More on
this in ↑7, Creating Beats with the Step Sequencer!
6.3.2 Editing Modulation
You edit any recorded modulation in the software. For this, the Control Lane is at your disposal
at the bottom of the Pattern Editor:
Applying Effects
Modulating Effect Parameters
MASCHINE MIKRO - Getting Started - 99
To Next Page
Loading...
Need help?
General
Weight and Dimensions
