1. Click in the display of the Mode selector at the left and select the Tube entry in the menu
that opens.
Upon your selection, the other parameters change in the Parameter area, giving you ac-
cess to settings specific to this saturation mode.
2. To adjust the various parameters, click and drag the knobs to change their values, and
click the buttons to activate/deactivate them.
6.2.1.2 Adjusting the Effect Parameters on the Controller
1. Check that the CONTROL button is lit — if not, press it to enter Control mode.
2. Press NAV + pad 2.
3. Press Left Arrow button repeatedly until the Parameter field reads 1/4: MODE at the bot-
tom of the display.
4. Turn the Control encoder until the Parameter field reads TUBE.
This selects the Tube mode of the Saturator.
5. Continue to scroll the various other parameters by pressing the Right Arrow and adjust
their values by turning the Control encoder.
6.2.2 Practice Makes Perfect!
Don’t hesitate to practice with loading effects in different places of the tutorial Project and ad-
justing their parameters. For example:
▪ You could load a Chorus on the Sound “Snare Ektl A 1” of the drum kit Group to slightly
widen its sound (use a low value for the Mix parameter of the effect).
▪ In that same drum kit Group, you could apply a slowly evolving Flanger on the Sound
“Shaker Ektl A” to make it livelier.
Applying Effects
Playing with Effects
MASCHINE MIKRO - Getting Started - 95
To Next Page
Loading...
Need help?
General
Weight and Dimensions
