⇨ A new Section slot is inserted right after Section slot 2 with the same properties and con-
tent (Scene). The existing Section slots are shifted one slot to the right to make way for
the new entry.
Note that the duplicate slot is automatically selected.
5. Press F3 (REMOVE) to remove this new Section slot from your arrangement.
→ The Section slot is removed. Sections to the right of the removed Section are shifted one
slot to the left to fill the gap.
9.3 Selecting a Loop Range
We already learned how to select a Section by clicking its Section slot in the software’s Arrang-
er or by pressing SCENE + the desired pad on your controller (see Adding other Sections). A
single selected Section is always looping automatically.
But MASCHINE also allows you to select several consecutive Sections and play them one after
the other in a loop. Here's how to select the desired range of Sections.
9.3.1 Selecting a Loop Range in the MASCHINE Software
The Arranger provides a timeline located above the slot labels that always show the current
loop range:
The Arranger timeline showing that the Section 2 is looped.
To select another loop range:
1. In the Arranger timeline, click the end column of the start Section and hold the mouse
button.
2. Drag horizontally onto the column of the end Section and release the mouse button.
Creating an Arrangement
Selecting a Loop Range
MASCHINE MIKRO - Getting Started - 130
To Next Page
Loading...
Need help?
General
Weight and Dimensions
