12. Press F3 above the display so that +PAT is deselected.
13. Turn the Control encoder until you see EK-TL A KIT at the bottom of the display.
14. Press the Control encoder to load that kit.
→ The drum kit is loaded into the first Group slot.
Now let’s leave the Browser and get back to the default Control mode of your controller:
► Press the lit BROWSE button to leave the Browser (the button is unlit).
That’s it! You just loaded a drum kit into a Group slot of MASCHINE. It is now ready to be
played from the pads, as you will see in the next section.
The process of loading from the Browser is the same for all kinds of objects: In the Browser, after
choosing the desired object (Project, Group, Sound, etc.), select the desired content, type, and sub-
type, then scroll through the result list and select an object for loading.
2.2 Playing with the Pads
As soon as a Group is loaded (here the EK-TL A Kit) and the corresponding Group slot selected
(here Group slot A), this Group can be played from the pads on your controller. Each pad trig-
gers one of the Sounds included in the Group.
First Steps
Playing with the Pads
MASCHINE MIKRO - Getting Started - 23
To Next Page
Loading...
Need help?
General
Weight and Dimensions
