Nautel Vector-LP VR125 - Page 11

Vector-LP Radio Beacon Transmitter Technical Instruction Manual Feb.24.09
Contents Page
3.6.2 Main Screens 3-18
3.6.3 Viewing Faults 3-20
3.6.4 Changeover Control 3-20
3.6.5 Viewing Events Log 3-20
3.6.6 Setting Real Time Clock 3-21
3.6.7 Setting RF Monitor Limits 3-22
3.6.8 Meter Settings 3-24
3.6.8.1 Changing Meter Groups 3-24
3.6.8.2 Selecting Analog Meter 3-25
3.6.8.3 Calibrating Analog Meter 3-25
3.6.9 Selecting Power Source 3-25
3.6.10 Configuring the Sonalert 3-26
3.6.11 Setting a Timed Shutdown 3-26
3.6.12 Changing Factory Calibrated Settings 3-27
3.6.12.1 Calibrating Diagnostic Display Meters 3-28
3.6.12.2 Setting Protection Threshold Levels 3-28
3.6.12.3 Setting Maximum Output Limitations 3-29
3.6.12.4 Using Factory Settings 3-29
3.6.13 Viewing and Setting Peripherals 3-30
3.6.13.1 Setting the Keyer 3-30
3.6.13.2 Viewing Power Module Status 3-31
3.6.13.3 ATU Controls 3-32
3.6.13.4 Testing the Standby Side 3-33
3.6.13.5 Selecting Peripherals 3-33
3.6.13.6 Checking Modules 3-34
3.6.14 Remote Control Monitor System Settings 3-34
3.6.14.1 Setting Control Points 3-34
3.6.14.2 Setting Monitor Points 3-35
3.6.14.3 Serial Settings 3-35
3.6.14.4 Automatic Reporting 3-35
3.6.15 Viewing Power Related Parameters and
Setting ATU Current Feedback 3-36
4 TESTING AND ADJUSTMENT
4.1 INTRODUCTION 4-1
4.2 OPERATING PRECAUTIONS 4-1
4.3 FUNCTIONAL TESTS 4-1
4.3.1 General 4-1
4.3.2 Test Equipment Required 4-3
4.3.3 Test Prerequisites 4-3
4.3.4 Initial Turn On 4-3
4.3.5 Standard Adjustments 4-4
4.3.6 Non-Standard Adjustments 4-8