Nautel Vector-LP VR125 - Introduction

Vector-LP Radio Beacon Transmitter Technical Instruction Manual Feb.24.09
Contents Page
2.2.14.3 Identification Code 2-10
2.2.14.4 Standby Codes 2-10
2.2.15 Serial Port Features 2-11
2.2.15.1 Remote Control and Monitoring Interface 2-11
2.2.15.2 ATU Interface 2-11
2.2.16 RF Monitoring Sample 2-11
2.2.17 Parts Supplied By Nautel 2-11
2.2.18 Parts Not Supplied By Nautel 2-11
2.2.19 Test Equipment and Special Tools 2-11
2.2.20 Available Options 2-11
2.3 INSTALLATION 2-13
2.3.1 Acceptance of Shipment 2-13
2.3.2 Unpacking Instructions 2-13
2.3.3 Visual Inspection 2-13
2.3.4 Cabinet Mounting 2-14
2.3.5 Determining Control/Monitor Requirements 2-14
2.3.6 Installing External Control/Monitor Wiring 2-14
2.3.7 Installing Ac Power Source Wiring 2-15
2.3.8 Installing Dc Power Source Wiring (Optional) 2-15
2.4 COMMISSIONING 2-17
2.4.1 Precautions 2-17
2.4.2 Turn-On Prerequisites 2-17
2.4.3 Initial Turn-On 2-17
3 OPERATING INSTRUCTIONS
3.1 INTRODUCTION 3-1
3.1.1 Precautions 3-1
3.2 EMERGENCY SHUTDOWN 3-1
3.2.1 Turn Off RF Output 3-1
3.2.2 Complete Shutdown 3-1
3.3 EXTERNAL SAFETY INTERLOCK 3-1
3.4 ELECTROSTATIC DISCHARGE PROTECTION 3-2
3.5 CONTROLS AND INDICATORS 3-2
3.5.1 Front Panel 3-3
3.5.2 Exciter Interface PWB 3-4
3.5.3 Remote Interface PWB 3-4
3.5.4 RF Synthesizer PWB 3-4
3.5.5 Miscellaneous Control and Exciter 3-4
3.5.6 Miscellaneous RF Power Stage 3-4
3.5.7 Battery Boost PWB 3-4
3.6 DIAGNOSTIC DISPLAY 3-18
3.6.1 Pushbutton Switches 3-18