NCR 7454 - Page 133

Chapter 3: Setup 3-41
Base I/O Address (Port C)
This option sets the base I/O address for serial port C.
1. Move the cursor to the Base I/O address option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Interrupt (Port C)
This option sets the interrupt for serial port C.
1. Move the cursor to the Interrupt option.
2. Press Enter and then select the desired setting from the drop-down
menu.
228
220
3F8
IRQ 5
IRQ 6
IRQ 7
IRQ 10
IRQ 11
IRQ 15