Chapter 3: Setup
Introduction
This chapter describes how to configure the BIOS CMOS options.
Following this Introduction, there are sections specific to Pentium
terminals and sections specific to Pentium III/Celeron terminals.
Note: An external alphanumeric keyboard is not required to run the
BIOS CMOS Setup Utility, but a keyboard makes the setup easier.
Note: The Setup Menus in this chapter reference NCR 7401/7454
BIOS Version 1.5.0.4 (Pentium) and NCR 7401/7452/7453/7454/7455
BIOS Version 2.1.2.0 (Pentium III).
Entering Setup Without a Keyboard
1. Apply power to the terminal.
2. Calibrate the touch screen.
a) When the screen prompt that says Touch the screen two times to
enter Setup appears, touch the screen three times. This causes
the system to bypass the BIOS Setup and go directly to the
Touch Screen Calibration Setup.
Note: Setup can also be entered from the Boot Menu that is
displayed when you press
ESC during POST.
b) As instructed on the screen, touch the circle near the lower-left
corner of the screen. For best results, press the screen near the
circle and then slide your finger onto the circle without raising
your finger from the screen.
To Next Page
Loading...
