Chapter 3: Setup 3-59
IDE Drive Monitoring
This option enables/disables activity on the IDE device to keep the
system awake.
1. Move the cursor to the IDE Drive x Monitoring option.
2. Press Enter and then select the desired setting from the drop-down
menu.
PCI Bus Monitoring
This option enables/disables activity on the PCI bus to keep the system
awake.
1. Move the cursor to the PCI Bus Monitoring option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Video Power State Control
This option is used to configure video power state behavior.
• Auto – video power state is always the same as the system power
state. Auto is the typical setting.
• Off, Suspend, Standby – video is set to Off, Suspend, or Standby
state during all system low-power transitions. Use Off, Suspend, or
Standby when your monitor behaves abnormally using the Auto
setting.
Disabled
Ena
To Next Page
Loading...
