3-54 Chapter 3: Setup
Security Menu Options
Supervisor Password Is: [Clear] Item Specific Help
User Password Is: [Clear]
Set Supervisor Password: [Enter]
Set User Password: [Enter]
Diskette access: [Supervisor]
Fixed disk boot sector: [Normal]
Password on boot: [Disabled]
Set Supervisor/User Password
The Supervisor Password controls access to the setup utility. The User
Password controls access to the system at boot. [Set] indicates that a
password is present. [Clear] indicates that a password is not present.
To enter a password, follow these steps:
Note: The User Password cannot be set until after the Supervisor
Password is set.
1. Move the cursor to the Set Supervisor Password or Set User Password
option and press Enter.
2. Key-in the password and press Enter.
3. Confirm the password by keying it in again and pressing Enter. A
Setup Notice confirms the changes have been saved.
4. Press Enter to return to the Security Menu Options screen.
Note: If the passwords are not known, the CMOS must be cleared as
described in Clearing the Passwords.
Main Advanced Securit
To Next Page
Loading...
