3-50 Chapter 3: Setup
ECC Config
Use this option only if all memory in the system supports ECC (x72).
1. Move the cursor to the ECC Config option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Disabled – all memory does not support ECC (x72)
• EC – checking only
• ECC – checking and correction
• ECC Scrub – checking, correction with scrubbing
SERR Signal Condition
This option selects the ECC error conditions that SERR# asserts.
1. Move the cursor to the SERR Signal Condition option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Disabled
EC
ECC
ECC Scrub
None
Single bit
Multiple bit
Both
To Next Page
Loading...
