Chapter 4: Operating System Recovery
Introduction
This chapter discusses procedures how to recover the Operating
System by using the parallel CD-ROM drive. The software is
distributed on bootable CD-ROM media. The drivers that are necessary
to run the CD-ROM are temporarily installed during boot.
It is also possible to perform a BIOS update using a network
connection. Refer to the NCR FitClient Software User's Guide for
information about that procedure.
Prerequisites
The following are required on the 7454 in order to perform a BIOS
update using a CD.
• Bootable CD-ROM drive (2336-K007)
• The terminal BIOS must be 1.02.00.00 or greater.
• Keyboard.
Caution: When performing an OS recovery from a larger source
image (larger disk) to a smaller destination disk you must use the
special procedure described in the OS Recovery from a Larger Disk Image
section that follows.
To Next Page
Loading...
