NCR 7454 - Setting up the PCMCIA Modem; Set-Up Option 1

B-10 Appendix B: Feature Kits
Setting Up the PCMCIA Modem
For 7454s with the Pentium III/Celeron running Windows NT, the
following two options show how the system can be configured and
what peripherals can be attached.
Set-Up Option 1
Set the modem is to use IRQ5 and I/O Address 3E8. This option gives
the user access to COM1 and COM2 (for use of scanner and printer),
MSR, Disk-On-Chip, and Parallel Port. Onboard LAN boot is the only
option disabled.
Bios Option Setting Default (Y / N)
Serial Port A 3F8 IRQ4 Y
Serial Port B 2F8 IRQ3 Y
Parallel Port 378 IRQ 7 Y
Floppy Disk Controller Enabled Y
Serial Port C Disabled N
Serial Port D Disabled N
Disk-On-Chip CE00-CFFF Y
MSR Address CC00-CDFF Y
MSR IRQ 15 Y
On-board Intel LAN ROM* Disabled N
On-board Intel PXE* Disabled N
Parallel CD-ROM Boot Optional N
* With this configuration the LAN Boot will be disabled. This does
not prevent LAN from working under OS.
** Parallel CD-ROM Boot can either be enabled or disabled.