2-26 Chapter 2: Hardware Installation
Wall Mounting a Tilt Mount
To install the Tilt Mount on a flat vertical surface, use the K533 Wall
Mount Bracket Kit .
1. Secure the Wall Plate to the wall with lag screws (4) into the studs
or with hardware of similar strength. The recommended viewing
height for the terminal is 1.2 m (48") from the floor.
16400
Wall Plate
Wall Mount Adapter Plate
Release Lever
2. Install the Wall Mount Adapter Plate to the bottom of the terminal
with screws (4).
3. Install the terminal to the Wall Plate. The bottom of the Wall Mount
Adapter Plate has slots that mate to locking tabs on the Wall Plate.
4. Latch the Release Lever.
To Next Page
Loading...
