NCR 7454 - Beep Error Codes

Chapter 3: Setup 3-47
Other
DOS
Beep Error Codes
The Beep Error Codes option enables/disables beep codes on error(s).
Move the cursor to Beep Error Codes, press Enter, and select On or Off.
Large Disk Access
1. Move the cursor to the Large Disk Access option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Select DOS for Windows NT O/S.
• Select Other if you are using UNIX, Novell NetWare, or other
type of operating system.
Note: Only the Windows NT Operating System is supported.
Local Bus IDE Adapter
This option is used to enable/disable the integrated local bus IDE
device to keep the system awake.
1. Move the cursor to the Local Bus IDE adapter option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Disabled
Enabled
Secondary
Both