NCR 7454 - Floppy Disk Controller

3-40 Chapter 3: Setup
Fdc On Lpt
This option enables/disables the primary floppy on the parallel port.
1. Move the cursor to the Fdc On Lpt option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Floppy Disk Controller
This option configures the Floppy Disk Controller. Since there is no
floppy disk on the terminal, this option is set to Disable.
Mode (Port C)
This option sets the mode for serial port C.
1. Move the cursor to the Mode option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Disabled
Enabled
Normal
IrDA
ASK-IR