B-18 Appendix B: Feature Kits
Installation Procedures
Connect the cable that is supplied with the kit to the terminal USB
connector. Refer to the 7454 Retail Terminal Software User’s Guide
for driver installation procedures.
15969d
USB Connector
Installing the Windows NT Drivers
1. Insert the Edgeport Driver disk into drive A.
2. From the Start Menu, select
Run.
3. Type
a:\setup and then click OK.
4. Click
Next at the Edgeport Drivers Install screen.
5. Read the Inside Out Networks Edgeport Software License. If you
agree, click
Yes.
6. Read the release notes and wait until you see the Installation
Complete screen. Click
Finish to restart the terminal. The new
communication ports are numbered sequentially, following the
existing ports in your system.
To Next Page
Loading...
