3-46 Chapter 3: Setup
Multiple ROM Menu
This option is used to load/unload specific ROMs the next time the
system is started.
1. Move the cursor to the Multiple ROM Menu option and press Enter.
2. Move the cursor to the Selectable ROM x option.
3. Press Enter and then select the desired setting from the drop-down
menu.
• Disabled – do not load ROM
• Enabled – load ROM in next boot
Note: Due to available space limitations, only enable the required
ROMs. Refer to the following table for ROM usage information.
ROM Use
On-board Intel
LAN
Intel Ethernet hardware-specific portion of the
Ethernet Boot ROM. Requires the On-board Intel
PXE ROM to also be enabled.
Parallel CD-ROM
Boot
Allows reloading of OS through a CD ROM
connected to the parallel port
On-board Intel PXE PXE protocol portion of the Ethernet Boot ROM.
Requires the On-board Intel LAN ROM to also be
enabled.
WaveLAN Boot ROM for WaveLAN 802.11 PCMCIA card.
Requires WaveLAN PXE to also be enabled.
WaveLAN PXE PXE protocol ROM for use with the WaveLAN
ROM.
Disabled
Enabled
To Next Page
Loading...
