4-4 Chapter 4: Operating System Recovery
If No is selected:
• The Ghost error file is displayed before rebooting only if Ghost
aborts.
Caution: If the error file is displayed, the batch file pauses for
user input before rebooting. You may use Ctrl-C to cancel out of
the batch file if you want to see the error file again, but nothing
should be done that writes to the hard disk before rebooting.
GHOST.ERR is on the RAM disk and is lost on reboot.
12. Select which type of recovery you want to perform from the next
menu (normally option #1).
1) Redo entire disk with the first partition the same size.
2) Redo the first OS partition.
3) Redo the second OS partition.
The Ghost software then begins the disk recovery from the CD. It
displays a progress bar and gives you an estimate how long the
process should take.
When the recovery process is completed, the client hard disk is
restored to its preinstalled condition, as originally received from
the factory.
13. At the completion of the recovery process remove the CD and press
ENTER to reboot the terminal.
14. Remove the CD during reboot for the OS to begin. When system is
restored, reset the BIOS to normal defaults.
Completing the OS Installation (WinNT)
The system automatically reboots when the image recovery is complete
and starts the software installation. This installation also installs most
of the additional software and drivers that are included in the disk
image. Complete the installation as follows.
1. After the terminal reboots, press Next at the Windows Setup screen.
2. Accept the Microsoft license agreement.
To Next Page
Loading...
