2-8 Chapter 2: Hardware Installation
7194 Printer
1. Connect the Printer Interface Cable to the RS-232 Connector on the
printer, located on the underside of the printer.
16632
RS-232 Connector
Power Connector
Cash Drawer Connector
2. Connect the other end of the printer cable to a USB port or one of
the RS-232 (non-powered) ports on the terminal.
3. Connect the Power Brick cable to the Power Connector on the
printer.
4. Plug the Power Brick into an AC outlet.
Note: For information about installing the printer using in-house
wiring, refer to the Feature Kits appendix.
To Next Page
Loading...
