Chapter 4: Operating System Recovery 4-3
3.
Apply power to the terminal so the CD-ROM drive can be opened.
4.
Insert the CD that contains the operating system image.
7454 Model Software CD LPINs
Win2000 WinNT Win98 Win95 DOS
7454-22xx D370-0489-010
5.
Boot the terminal.
6.
Press
F2
at the screen prompt to enter Setup.
7.
In the
Advanced
menu, select
I/O Device Configuration
.
8.
Verify that the
LPT 1 Mode
is set to
ECP
.
9.
Go back to the
Advanced
menu, select
Multiple ROM Menu
.
10.
Set the
Parallel CD-ROM Boot
to
Enabled
.
11.
Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
12.
Follow the DOS screen prompts. After each entry you are asked to
confirm your input. You can use
1
or
y
for Yes,
2
or
n
for No.
13.
Enter whether or not you want to perform
Disk verification
.
(Answering Yes takes twice as long, but is recommended.)
If Yes is selected:
•
The Ghost
®
software verifies write operations and handles bad
FAT clusters.
•
The Ghost error file (GHOST.ERR) is displayed before
rebooting
To Next Page
Loading...
