NCR RealPOS 70 - Page 108

4-12 Chapter 4: Touch Screen Calibration – Windows (MT 5.64, SR4)
17. AWarningdialogboxisdisplayedwhilethedataissaved.Donot
touchthescreenuntilthisdialogboxisnolongerdisplayed.

18. Testthecalibrationbymovingyourfingeraroundonthescreen
andverifyingthatthecursorfollowsyourfinger.Itisalso
suggestedthatyouTouchall4Cornersandverifythatthecursor
movesdeeplyintothecorners.
19. SelectDone.

20. IfyouaresatisfiedwiththecalibrationresultsyoucanselectClose
toexittheTouchWareprogram.
Ifthesystemisstilloutofcalibrationafterperformingthe2‐Point
CalibrationthenperformtheCursorStabilizationprocedure(followthe
flowchartbeginningatCursorStabilization).