NCR RealPOS 70 - BIOS Updating Steps

Chapter 16: BIOS Updating Procedures 16-3
BIOS Updating Procedures
1. Connectakeyboardtotheterminal.
2. Applypowertotheterminal.
3. Press[DEL]duringboottoenterSetup.
4. AttheSetupUtilitymenu,selectAdvanced BIOS Features.
5. SettheFirst Boot DevicetoUSB-CDROM.
Note: TheCDROMselectionisusedwhenyouwanttobootfrom
aninternalCD‐
ROMdrive.
6. Press[Esc]toreturntotheSetupUtilitymenu.
7. SelectSave and Exit Setup.
8. InsertthemediacontainingtheBIOSupdatesoftware.
9. FollowthescreenpromptsontheclienttoupdatetheBIOS.You
canselecttwomethodstoruntheupdateprogram.
• AutomaticBIOSUpdate
–updateprocessrunsunattended
Note: Youwillseeapromptforterminalmodelandserial
numberinformationiftheprogramdetectsinvalidinformation
inthecurrentBIOS,orifyouarereplacingtheprocessorboard,
inwhichcasethereisnotmodel/serialnumberinformationin
theBIOS.
Important:Model/SerialNumber
ismandatory.
• InteractiveBIOSUpdate–permitsyoutoinput/replacethe
model/serialnumberinformationthatisstoredintheBIOS.
Note: Model/Serialnumberdatathatiscurrentlystoredinthe
BIOSisdisplayedduringpowerup.
10. TheFlashprogramupdatestheBIOSandthenrebootstheterminal.
11. Remove
theCDbeforethesystemreboots.