NCR RealPOS 70 - Restore Factory Settings; Reset Controller; Advanced Touch Screen Options

Chapter 3: Touch Screen Calibration – Windows (MT 7.12) 3-33
Restore Factory Settings
Software
TheResetSoftwareoptionisusefulifyouhavereconfiguredthe
softwareandneedtogetbacktoaworkingstate.Thisoptionrestores
theoriginalfactorydefaults.
Controller
TheRestoreControlleroptionisusefulifyouhavereconfiguredthe
controllerandneedtogetbacktoaworkingstate.Pressing
thisbutton
restorestheoriginalfactorydefaults.
Ifafterrestoringcontrollerfactorydefaultsyoulosethetouch
functionality,rebootthesystem.
Note: Youmustperformacalibrationafterrestoringcontroller
defaults.
Reset Controller
UsethisonlyatthedirectionofTechnicalSupport.Thiscommand
initializesthehardwareandthefirmware,causesthecontrollertostop
sendingdata,andrecalculatestheenvironmentalconditions(i.e.stray
andoffsetvalues).TheResetControllercommandalsocancelsexisting
commandsandreturnsthecontrollertonormaloperation.
Advanced Touch Screen Options
TheonlyadvancedoptionistheLinearizationprocedure.
SeetheLinearizationsection.