NCR RealPOS 70 - Installation Restrictions and Guidelines

2-2 Chapter 2: Installing the Terminal
Installation Restrictions
• Beforeinstallingtheterminal,readandfollowtheguidelinesinthe
NCRRealPOS72SitePreparationGuide(B005‐0000‐1464)andthe
NCRWorkstationandPer i pheralACWiringGuide(BST0‐2115‐53).
• Installtheterminalnearanelectricaloutletthatiseasilyaccessible.
Usethepowercordasa
power‐disconnectdevice.
• Donotpermitanyobjecttorestonthepowercord.Donotlocate
theterminalwherethepowercordcanbewalkedon.
• Useagroundingstraportouchagroundedmetalobjectto
dischargeanystaticelectricityfrom yourbodybeforeservicingthe
terminal.
• Ifthepowercordisreplaced,itmustbereplacedwiththesame
typeofcordwiththeprotectiveshroud.
• Donotroutethepowercordthroughopeningswithsharpedges.
Warning: Thisunitcontainshazardousvoltagesandshouldonlybe
servicedbyqualifiedservicepersonnel.
Warning: DONOT
connectordisconnectthetransactionprinter
whiletheterminalisconnectedtoACpower.Thiscanresultin
systemorprinterdamage.
Warning: DONOTconnect ordisconnectanyserialperipherals
whiletheterminalisconnectedtoACpower.Thiscanresultin
systemorprinterdamage.
Warning: TheNCR742
terminalsmustbemountedsecurelyto
preventahazard.Theymustbeinstalledinaccordancewithlocal
buildingcodes.Thepostorwallonwhichtheunitismounted
shouldbeabletowithstandfourtimestheweightoftheunit.