NCR RealPOS 70 - Draw Test

3-32 Chapter 3: Touch Screen Calibration – Windows (MT 7.12)
Draw Test
Note: YoumustbeinDrawModeforthistoworkproperly.
TheDrawprogramletsyoutesttheoperationofthetouchscreenby
checkingtheaccuracyandspeedwithwhichthesystemrespondsto
yourtouch.Todraw,simplytouchthescreenanddragyourfinger.It
isrecommended
thatyoucalibrateagainifverticalandhorizontallines
(exceptaroundtheouterbezel)aremorethan6mmfromthetouch
point.

Thefollowingoptionswillhelpyouusethedrawprogrammore
effectively:
• PressB(blank)toclearthescreenanddisplayablankdrawing
canvas.
• PressG(grid)toclearthescreenanddisplayagridthatyoucan
useasadrawingguide(default).
• PressL
(line)todrawsolidlinesonthescreen(default).
• PressD(dots)todrawdottedlinesonthescreen,whereeachdot
representsapointreportedbythetouchscreen.
• PresstheSpaceBartoclearthescreen.