NCR RealPOS 70 - Touch Calibration Procedures Overview

3-12 Chapter 3: Touch Screen Calibration – Windows (MT 7.12)
Touch Calibration Procedures
UsetheTouchWareutilitiestoperformthefollowingprocedures:
• 3‐PointCalibration
• 25‐PointLinearization
• RestoreDefaults
TheTouchWareutilitiesareavailableontheNCRGoldDrivesfor
WinXPPro,WinXPe,andWePOS.
Note: CustomerswhoarerunningaWindowsapplicationshould
alwaysuseTouchWaretocalibrate.Do
notbootintoDOSandrun
Microcal.
Applicationsoftwarecanpossiblygenerateadialogboxfromthe
TouchDriver,withthemessagethatthetouchscreenneedstobe
recalibrated.Ifthescreenappearstobeworkingnormally,thenthis
messagecanbeignored.Therewillbeacheckboxlabeled

Do not show this message again.Makesurethisboxis
checked.