NCR RealPOS 70 - Installing the Touch Screen Driver

5-2 Chapter 5: Touch Screen Calibration – Windows (MT 5.64, SR6)
Installing the Touch Driver
TheTouchdriverisincludedontheGoldImagefromNCR.However,
ifyouarebuildingyourownimagethenyoumustinstalltheTouch
drivermanuallyasfollows.
Note: IfaWindowsdriver(printer)isalreadyinstalledonCom1or
Com2priortoinstallingtheTouchWaredriveron
Com3,the
installationwillencounterproblems.
UninstalltheWindowsdriver
priortoinstallingtheTouchWaredriver.Theprintercanbere‐
installedafterTouchWareisinstalled.
ThissoftwareisavailableontheNCRWebSite.
http://www.ncr.com
1. Atthissite,selecttheSupporttab.
2. SelectDrivers and Patches→Retail Support Files→NCR
RealPOS and SelfServ Terminal and Operating Systems→
NCR EasyPoint 42 (7402)→Windows→Windows2000.
3. DownloadtheTouchSoftware:TW564SR6.zip.
Note: IfyoucurrentlyhavetheMT7.12driverinstalledfirst
uninstallit.
a. RemovethedriverusingtheAdd/RemoveProgramsappletin

Windows
b. ManuallyremovethefollowingRegistryentriesusingRegedit.
\HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\TwBUS
\HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\TwTouch
c. InstalltheTW5.64software.
4. Extracttheinstallationfilesintotoaworkingdirectoryonthehost
terminal.FourfoldersarecreatednamedDisk1,Disk2,Disk3,Disk4.
5. Runthe Setup.exeprogramlocatedintheDisk1folder.