NCR RealPOS 70 - Chapter 3: Touch Screen Calibration

To Next Page

To Previous Page

Chapter 3: Touch Screen Calibration – Windows

(MT 7.12)

Note: Thischapterdiscussescalibrationproceduresusing

MicroTouch,Version7.12.

General Guidelines

ObserveforthefollowingTouchScreencalibrationguidelines:

• Calibratethetouchscreenaspartoftheinitialinstallation.

• Recalibratewhenevertheterminalismovedtoanewlocation.

• Recalibrateafterreplacinganycomponentintheterminal.

• Recalibratewheneveracustomerreportsatouchscreenproblem.

• Recalibrate

ifyouswitchtoanewscreenresolution

UsetheTouchWareutilitiestoperformthefollowingprocedures:

• 2‐PointCalibration

• CursorStabilization

• 25‐PointLinearization

• RestoreDefaultsProcedure

TheTouchWareutilitiesareavailableontheNCRGoldDrivesfor

WinNT,Win2K,WinXPProandWinXPe.

Application

softwarecanpossiblygenerateadialogboxfromthe

TouchDriver,withthemessagethatthetouchscreenneedstobe

recalibrated.Ifthescreenappearstobeworkingnormally,thenthis

messagecanbeignored.TherewillbeacheckboxlabeledDo not

show this message again.Makesurethisboxischecked.



NCR RealPOS 70 - Chapter 3: Touch Screen Calibration - Windows (MT 7.12)