NCR RealPOS 70 - Single Display Mode Setup

Chapter 7: Installing a Secondary (Dual) Display 7-3
Single Display Mode Setup
1. SelectMonitororDigital Display.
2. Select
Apply.
3. Select
OK.
4. ChangeDevice Settingspertheattacheddisplay.
Note: ChangingphysicaldisplaytypesbetweenO/Sbootsmayresult
inhavingnodisplayinWindows.BothWindowsandtheBIOS
rememberthepreviouslyattacheddisplaytype.Thiswilloccurifa
DVIdisplayisreplacedwithaVGAdisplayorviceversa.
InWindows,
SettheIntelControlPaneltoClonemodeBEFOREchangingthe
displays(seebelow).