Electra Elite IPK II Document Revision 1
Call Forwarding, Off-Premise 2 - 115
25-07-07 System Timers for VRS/DISA - DISA/Tandem Trunking Long Conversation Warning Tone
Time
Determine the length of time a DISA caller or any trunk-to-trunk (such as Tandem Trunking)
conversation can talk before the Long Conversation tone is heard (0-64800 seconds).
25-07-08 System Timers for VRS/DISA - DISA/Tandem Trunking Long Conversation Disconnect
This timer determines how long the system will wait before disconnecting a DISA or any
trunk-to-trunk (such as Tandem Trunking) call after the Long Conversation tone is heard
(0~64800 seconds).
Trunk-to-Trunk Forwarding - Normal (0) Trunks (in addition to above programming)
11-10-06 Service Code Setup (for System Administrator) - Setting the Automatic Trunk Forwarding
Customize the service code to be used to set the Automatic Trunk Forwarding feature (default:
733).
11-10-07 Service Code Setup (for System Administrator) - Cancel the Automatic Trunk Forwarding
Customize the service code to be used to cancel the Automatic Trunk Forwarding feature
(default: 734).
11-10-08 Service Code Setup (for System Administrator) - Automatic Trunk Forwarding Destination
Customize the service code to be used to set the destination for the Automatic Trunk Forwarding
feature (default: 735).
13-01-01 Abbreviated Dialing Function Setup - Abbreviated Dialing Auto Outgoing Call Mode
Determine if dialing an Abbreviated Dialing number will dial an outside number (seizing a trunk
as assigned in Program 13-05) or an Intercom number (0 = Trunk Dialing Mode, 1 = Extension
Dialing Mode).
13-04-01 Abbreviated Dialing Number and Name
Enter the Common and Group Abbreviated Dialing numbers and names which are to be used for
Trunk-to-Trunk Forwarding.
20-06-01 Class of Service for Extensions
Assign a Class Of Service (1~15) to an extension.
20-07-05 Class of Service Options (Administrator Level) - Automatic Trunk-to-Trunk Forwarding
Enable (1) or disable (0) an extension’s ability to use the Trunk-to-Trunk Forwarding service
codes.
22-02-01 Incoming Call Trunk Setup - Incoming Type
Used to assign the incoming trunk type for each trunk. There is one item for each Mode. When
using Trunk-to-Trunk Forwarding the trunks must be set for Normal (0).
24-04-01 : Automatic Trunk-to-Trunk Transfer Target Setup
Assign the Abbreviated Dialing number bin (0~1999) to a trunk and the time mode which should
be used as the destination of the Automatic Trunk-to-Trunk Forwarding.
Trunks: 001~200
Time Modes: 1~8
To Next Page
Loading...
