Electra Elite IPK II Document Revision 1
Caller ID 2 - 153
20-19-05 System ID Options for Caller ID - Caller ID Sender Queuing Timer
With the Caller ID Sender Queuing option, determine how long an incoming call will wait in
queue for a DSP resource to become available (0~64800 seconds). If a resource becomes
available during this time, the call will immediately ring the single line telephone with Caller ID. If
the timer expires before a resource becomes available, then system rings the single line
telephone without Caller ID (until the timer expires, the single line telephone will not ring). If the
queuing timer is set to "0", the system does not queue the incoming call.
20-20-01 Message Setup for Non-Caller ID Data - Private Call
Enter the text (up to 24 alphanumeric characters) to be displayed for Caller ID when a user
receives a call which is classified as a private call.
20-20-02 Message Setup for Non-Caller ID Data - Out of Service Area
Enter the text (up to 24 alphanumeric characters) to be displayed for Caller ID when a user
receives a call which is classified as a an out-of-service area call.
20-20-03 Message Setup for Non-Caller ID Data - Call Information with Error
Enter the text (up to 24 alphanumeric characters) to be displayed for Caller ID when a user
receives a call which is classified as a call with a CID error.
90-03-01 Save Data
This command is used for saving the programmed data on the SRAM and Flash ROM to the
Removable Compact Flash Memory.
90-04-01 Load Data
This command is used for loading the data from inserted Compact Flash Memory to SRAM and
Flash ROM.
Operation
Storing a Number
To store a Caller ID number in an Abbreviated Dial bin:
1. With a multiline terminal in an idle condition the display shows:
2. Press the LIST Softkey. The display shows:
1-01 FRI 09:00AM
301 STA 301
LIST DIR ICM PROG
LIST MENU
Redial CID
To Next Page
Loading...
