Electra Elite IPK II Document Revision 1
Conference 2 - 229
If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
If the call being added is busy/unanswered:
With an outside call, press the line or Call Appearance (CAP) key for a call previously added to the Conference.
The unanswered call will drop and the initiator will be back into the Conference call.
Adding an Intercom call to an outside Conference call: Press the Conf softkey on the Multiline Terminal display
or the Conf key twice to re-establish the Conference. If using a non-display telephone, press the Conf key twice.
With only Intercom calls in the Conference: Press the Conf key twice to re-establish the Conference. If the voice
mail answers, there is no way to drop that extension out. You will need to drop the Conference call.
5. Repeat steps 2~4 to add more parties.
Single Line Telephone
1. Establish Intercom or trunk call.
2. Hookflash and dial #1.
3. Dial extension you want to add.
- OR -
Access trunk call.
- OR -
Retrieve call from Park orbit.
4. Hookflash and repeat step 3 to add more parties.
- OR -
Hookflash twice to set up the Conference.
To Split (alternate) between the parties in Conference:
Multiline Terminal
1. Press Conf (Transfer) or Conference key (PGM 15-07 or SC 751: 07).
2. Dial Split service code (794).
Repeat this procedure to alternate between the remaining parties in the Conference. Press the Conf softkey or the
press the Conf key twice to set up the Conference again.
Single Line Telephone
1. Hookflash and dial 794.
Repeat this procedure to alternate between the remaining parties in the Conference. Hookflash twice to set up the
Conference again.
To Next Page
Loading...
