Electra Elite IPK II Document Revision 1
Account Code Entry 2 - 13
Related Features
Abbreviated Dialing
Automatic Route Selection (ARS)
One-Touch Calling
PBX Compatibility
Station Message Detail Recording
Programming
14-01-11 Basic Trunk Data Setup - Account Code
Enable (1) or disable (0) Account Codes for each trunk.
15-07-01 Programming Function Keys
Assign a function key as an Account Code key (code 50). Use this key instead of the dial pad to
enter the
,
before and after the Account Code.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
21-01-04 System Options for Outgoing Calls - Dial Tone Detection Time
Adjust the interval the system will wait for a user to enter an Account Code. By default, this
option is set to 5 (Entries: 0-64800 seconds).
35-05-01 Account Code Setup - Account Code Mode
For each Class of Service (1~15) use this option to select the Account Code Mode. The options
are:
0 Account Codes disabled. (Any codes you enter dial out as part of your initial call.)
1 Account Codes optional (not required).
2 Account Codes required (forced) but not verifiable.
3 Account Codes required (forced) and verifiable.
35-05-03 Account Code Setup - Account Codes for Incoming Calls
For each Class of Service (1~15), enter 1 in this option to enable Account Codes for incoming
calls. Enter 0 to disable Account Codes for incoming calls. If disabled, any codes you enter dial
out on the connected trunk.
35-05-04 Account Code Setup - Hiding Account Codes
For each Class of Service (1~15), enter 1 to have the system hide Account Codes on an
extension’s display as they are entered. Enter 0 to have the Account Codes displayed.
To Next Page
Loading...
