Electra Elite IPK II Document Revision 1
Account Code – Forced/Verified/Unverified 2 - 19
Conditions
If a user enters a code that exceeds the 16 digit limit, the system ignores the Account Code
entry.
If the system has Account Codes disabled, the digits dialed (e.g.,
∗1234∗) appear on the
SMDR report as part of the number dialed.
If using Forced Account Code with single line telephone you will needs a VRS to get the
prompts to enter the Forced Account Code.
When you use Forced Account Code on only toll calls and you dial a local call you will hear
a beep.
Speed Dial – System/Group/Station bins can contain stored Account Codes. They can be
prevented from being displayed using 20-07-04.
Automatic Route Selection (ARS) can force a user to enter an Authorization Code prior to
using a certain route. The system verifies the ARS Authorization Code dialed against the
ARS Authorization Code list (Program 44-03).
To simplify Account Code entry, store the Account Code (e.g.,
∗1234∗) in a One-Touch
Key. Just press the key instead of dialing the codes.
Account Codes appear on the SMDR report (even if they are hidden on the telephone’s
display).
When using a PBX/CTX trunk and Account Codes, do not use an asterisk as part of the
PBX/CTX access code. Otherwise, after the
∗, the trunk would stop sending digits to the
central office.
Account Codes for incoming calls not available for single line telephones.
Default Settings
Account Codes are disabled.
System Availability
Terminals
Any Station
Required Component(s)
VRS for Forced Account Codes for Single Line Telephones
To Next Page
Loading...
