Document Revision 1 Electra Elite IPK II
2 - 20 Account Code – Forced/Verified/Unverified
Related Features
Automatic Route Selection (ARS)
PBX Compatibility
Speed Dial – System/Group/Station
Station Message Detail Recording
Programming
14-01-11 Basic Trunk Data Setup - Account Code
Enable (1) or disable (0) Forced Account Codes for each trunk.
15-07-01 Programming Function Keys
Assign a function key as an Account Code key (code 50). Use this key instead of the dial pad to
enter the
,
before and after the Account Code.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
20-13-20 Class of Service Options (Supplementary Service) - Account Code/Toll Restriction
Operator Alert
In an extension’s Class of Service, turn On (1) or Off (0) the Operator Alert when a forced
account code is incorrectly entered.
21-04-01 Toll Restriction Class
Use this option to assign a Toll Restriction Class (1~15) to an extension.
35-05-01 Account Code Setup - Account Code Mode
For each Class of Service (1~15) use this option to select the Account Code Mode. The options
are:
0 Account Codes disabled. (Any codes you enter dial out as part of your initial call.)
1 Account Codes optional (not required).
2 Account Codes required (forced) but not verifiable.
3 Account Codes required (forced) and verifiable.
35-05-02 Account Code Setup - Forced Account Code Toll Call Setup
For each Class of Service (1~15), enter 1 in this option to enable Forced Account Codes for just
toll calls. With this option enabled, local calls will have Optional Account Codes. Enter 0 to
enable Forced Account Codes for local and toll calls. If a user needs to dial
,
as part of
post-dialing digits, the
,
must be pressed three times (twice for the expected account code entry
and the third as the post-dialing digit).
To Next Page
Loading...
