Electra Elite IPK II Document Revision 1
Elite CallAnalyst 2 - 397
J
Caller ID name can be displayed in SMDR records. Program 35-02-17 must be set to “0” and
Program 35-02-18 set to “1”.
14-01-06 Basic Trunk Data Setup - SMDR Print Out
Use this option to have the system include (1) or exclude (0) the trunk being programmed for the
SMDR printout.
15-01-03 Basic Extension Data Setup - SMDR Printout
For each extension, enter 1 if an extension‘s call should appear on the SMDR report. Enter 0 for
the extension if the calls should not appear.
35-01-01 SMDR Options - Output Port Type
This option specified the type of connection used for SMDR.
0 = No Setting
1 = CPUII ( )-( ) COM Port 1
3 = LAN,
4 = CTA)
The baud rate for the serial COM port should be set in Program 10-21-02 or 15-02-19 or set the
IP address and port number in 10-12-01 and 10-20-01.
35-01-02 SMDR Options - Output Destination Number
This option specified the SMDR printer output extension (CTA extension number).
35-01-03 SMDR Options - Header Language
Specify the language in which the SMDR header should be printed.
(0=English, 1=German, 2=French, 3=Italian, 4=Spanish).
This entry must be “0” for Elite CallAnalyst.
35-01-04 SMDR Options - Omit Digits
The number of digits entered for this option do not print on the SMDR Report (0-24). For
example, if the entry is 10, the first 10 digits a user dials do not appear on the SMDR report.
35-01-05 SMDR Options - Minimum Digits
Outgoing calls must be at least this number of digits for inclusion in the SMDR report (0~24).
35-01-06 SMDR Options - Minimum Call Duration
A call must last at least this interval to be included in the SMDR report. (0 = All, 1~65535
seconds).
35-01-07 SMDR Options - Minimum Ring Time
A call must ring for at least this interval to be included in the SMDR report (0 = All, 1~65535
seconds).
35-01-08 SMDR Options – SMDR Format
This option should be left at it’s default setting of “0”.
To Next Page
Loading...
