Document Revision 1 Electra Elite IPK II
2 - 398 Elite CallAnalyst
35-02-01
to
35-02-18 SMDR Output Options
Set the various print options for SMDR.
35-03-01 SMDR Port Assignment for Trunk Group
Assign the SMDR port for each trunk group. This is the SMDR port to which the incoming call
information should be sent.
Trunk Group: 1~100,
SMDR Port: 1~8
35-04-01 SMDR Port Assignment for Department Groups
Assign the SMDR port for each department group. This is the SMDR port to which the outgoing
call information should be sent.
Department Group: 01~64
SMDR Port: 1-8
CTA Adapter:
15-02-19 Multi-Line Telephone Basic Data Setup - CTA Data Communication Mode
Change the system programming to match the CTA adapter‘s dip switch settings.
15-02-20 Multiline Telephone Basic Data Setup - Baud Rate for CTA Port
Select the baud rate to be used by the CTA Adapter.
0 = 4800
1 = 9600
2 = 19200
LAN Connection:
10-12-01 CPUII( )-U( ) Network Setup – IP Address
When using an IP connection, set up the IP address used to connect from the CallAnalyst PC to
the system (default: 172.16.0.10).
10-20-01 LAN Setup for External Equipment
When using an IP connection, define the TCP port used for communicating to the CallAnalyst
(External Device 5 = SMDR, Entries: 0~65535). This entry must match the entry made in the
CDM setup with the CallAnalyst program.
To Next Page
Loading...
