Electra Elite IPK II Document Revision 1
IP Station (MEGACO) - MG 16 2 - 473
84-05-02 VOIP LAN Interface Setup
Use this program to define the LAN interface Speed and Mode of the VoIP Application supported
(MG16, CCISoIP).
(default: 0 = AUTO)
84-05-03 VOIP MGC Master Slave Setting
Use this program to define the Media Gateway Controller for the MG16 application.
(default: 1:MASTER)
The Elite IPK II system will only support “1” Media Gateway controller, this is determined by setting the
MG16 Application to “Master”.
84-05-03 VOIP MG Subnet Mask
Use this program to define the Media Gateway Card Subnet Mask.
(default: 255.255.0.0)
84-05-03 VOIP MGC Master Slave Setting
Use this program to define the Default Gateway Card Default Gateway.
(default: 0.0.0.0)
84-06-01 VOIP Setup - RTP Port Number
Use this program to define the Media Gateway Card starting RTP Port Number.
(default: 10020)
84-06-02 VOIP Setup – RTCP Port Number
Use this program to define the Media Gateway Card Starting RTCP Port Number . The RTCP
Port Number has to be the (RTP port number + 1).
(default: 10021)
84-06-04 VOIP Setup – Fractlost Threshold
Use this program to define the fractional lost threshold – this data will be sent to the IPK II CPU
when the value exceeds the defined value.
(default: 0.)
84-06-05 VOIP Setup – Packet Lost Threshold
Use this program to define the packet lost threshold - this data will be sent to the IPK II CPU
when the value exceeds the defined value.
(default: 0)
84-06-06 VOIP Setup – Ext High Sequence
Use this program to define the high sequence threshold - this data will be sent to the IPK II CPU
when the value exceeds the defined value.
(default: 0)
84-06-07 VOIP Setup – Jitter Threshold
Use this program to define the Jitter Threshold - this data will be sent to the IPK II CPU when the
value exceeds the defined value.
(default: 0)
To Next Page
Loading...
