NEC ELECTRA ELITE IPK II - Page 496

Document Revision 1 Electra Elite IPK II
2 - 474 IP Station (MEGACO) - MG 16
 84-06-08 VOIP Setup – Last LSR Threshold
Use this program to define the Last LSR Threshold - this data will be sent to the IPK II CPU
when the value exceeds the defined value.
(default: 0)
 84-06-09 VOIP Setup – Delay LSR Threshold
Use this program to define the Delay threshold – this data will be sent to the IPK II CPU when
the value exceeds the defined value.
(default: 0)
VOIP ToS Setup
The Elite IPK II supports Qos Marking for the following VoIP Applications Media Gateway Card (MG16)
Application the ToS and DiffServe.
 84-10-01 ToS Mode
Use this program to define the logic used for marking the ToS Field.
(default: 0)
 84-10-02
through
84-10-06 IP Precedence
Use this program to define the IP Precedence data bit.
 Typically, only one of the bits 3 – 6 are set to 1 and the other three bits are set to 0. For example, to
maximize route reliability, set 84-10-05 to 1, and leave 84-10-03, 84-10-04 and 84-10-06 to be at default
(0).
(default: 0)
 84-10-07 Priority (Diffserv)
Use this program to define the Diffserv – decimal value {valid values 0~63).
(default: 0)
IP Phone Configuration
IP Telephone Terminal Basic Data Setup:
 15-01-01 Terminal Type [Informational Only]
Use this program to review the type protocol support by the IP phone.
(default: MEGACO)
 15-05-02 IP Phone Fixed Port Assignment [Informational Only}
Use this program to review the registered IP Phone Mac Address.
(default: 00-00-00-00-00-00)
 15-05-06 IP Phone Type
Use this program to define the type of IP Phone being utilized – valid options are IP70, IP80 or
IP Soft Phone.
(default: 0)