Document Revision 1 Electra Elite IPK II
2 - 526 ISDN Compatibility
15-01-04 Basic Extension Data Setup - ISDN Caller ID
If both Program 15-01-04 and 10-03-05 are enabled (1), the system includes Caller ID in the
Setup message as “Presentation Allowed”. If these options are disabled (0), it will be
“Presentation Restricted”.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
20-08-13 Class of Service Options (Outgoing Call Service) - ISDN CLIP
Determine if the ISDN calling line identity presentation and screening indicators are to be
allowed:
0 = Disabled (Default)
1 = Enabled
21-13-01 ISDN Calling Party Number Setup for Extensions
Assign each extension a Calling Party Number (maximum 16 digits per entry). The calling
number is the subscriber number of the dial-in number. When a call is made by an extension
which does not have an Extension Calling Number assigned (Program 21-12), the system sends
the calling number for the ISDN trunk defined in Program 21-13. If a Calling Party Number is
assigned in both Programs 21-12 and 21-13, the system sends the data in Program 21-13.
SMDR Dialed Digits for either ISDN - BRI or PRI
35-02-15 SMDR Output Options - CLI / DID Number
Determine if the CLI/DID Number should be displayed.
0 = Caller ID Number (Default)
1 = DID Calling Number
2 = Caller ID Name
35-02-16 SMDR Output Options - Trunk Name or Received Dialed Number
Determine how the SMDR should print incoming calls on ANI/DNIS or DID trunks. If set to (1),
ANI/DNIS trunks can print DNIS digits, if set to (0) trunk names are printed instead.
For additional SMDR Services refer to Station Message Detail Recording on page 2-771.
Two B-Channel Transfer for ISDN - PRI
10-03-16 ETU Setup - ISDN 2 B-Channel Transfer
Enable or disable the 2 B-Channel Transfer function for a PRI PCB.
0 = Disable (Default)
1 = Enable
20-11-21 Class of Service Options (Hold/Transfer Service) - Restriction for Tandem Trunking on
Hang Up
Allow (0) or deny (1) an extension user’s ability to set up a tandem call automatically when they
hang up. By default, this option is allowed (0). Required for 2 B-Channel Transfer.
To Next Page
Loading...
