Electra Elite IPK II Document Revision 1
ISDN Compatibility 2 - 525
DID Services for either ISDN - BRI or PRI
22-02-01 Incoming Call Trunk Setup - Incoming Type
Assign the incoming trunk type for each trunk.
0 = Normal (Default) 4 = DIL
1 = VRS (Second dial tone if no VRS installed) 5 = E&M Tie line
2 = DISA 6 = Delayed DID
3 = DID 7 = ANI/DNIS
22-11-01 DID Translation Table Number Conversion - Received Number
For each DID Translation Table entry (1~2000), specify the digits received by the system (eight
maximum).
22-11-02 Translation Table Number Conversion - Target Number
For each DID Translation Table entry (1~2000), specify the extension the system dials after
translation (24 digits maximum).
22-09-01 DID Basic Data Setup - Expected Number of Digits
For each DID Translation Table (1-20), enter the number of digits the table expects to receive
from the CO (8 maximum). For example, for a table used with 3-digit DID service, enter 3.
For additional DID Services refer to Direct Inward Dialing (DID) on page 2-285.
Calling Party Number Presentation for either ISDN - BRI or PRI
Calling Line Identification Presentation (CLIP)
10-03-05 ETU Setup - CLIP Information
Based on this setting, the system will include a “Presentation Allowed” (1) or “Presentation
Restricted” (0) in the Setup message to allow or deny the Calling Party Number. Program
15-01-04 must also be set to a ‘1’ if this option is enabled.
21-12-01 ISDN Calling Party Number Setup for Trunks
Assign Calling Party Numbers for each trunk (maximum 16 digits per entry). When a call is made
by an extension which does not have an Extension Calling Number assigned (Program 21-13),
the system sends the calling number for the ISDN trunk defined in 21-12. If the Calling Party
Number is assigned in both Programs 21-12 and 21-13, the system sends the data in Program
21-13.
Calling Party Number Presentation from Station
10-03-05 ETU Setup - CLIP Information
Based on this setting, the system will include a “Presentation Allowed” (1) or “Presentation
Restricted” (0) in the Setup message to allow or deny the Calling Party Number. Program
15-01-04 must also be set to a ‘1’ if this option is enabled.
To Next Page
Loading...
