NEC ELECTRA ELITE IPK II - Page 552

Document Revision 1 Electra Elite IPK II
2 - 530 ISDN Compatibility
Should the sub-address
ID be displayed for
incoming calls?
Is SMDR used?
In 20-09-03, set the
extension's COS to '1'.
In 20-09-03, set the
extension's COS to '0'.
In 35-02-16, enter '0' to
print the trunk port name
assigned in 14-01-01 or
enter '1' to print the
received dialed number.
A
YesNo
Should an extension
be able to display the reason why
a call is transferred to it?
In 20-13-23, set the
extension's COS to '0'.
In 20-13-23, set the
extension's COS to '1'.
No Yes
Define the extension's
Class of Service in 20-06-01.
Yes
Should all PRI
Trunks ring the same
extensions?
In 22-02-01, enter 3.
Refer to the Elite IPK II
Manual for DID
programming.
No
In 22-02-01, enter
0.
Yes No
In 22-05-01, assign all the trunks on a
PRI ETU to the same Ring Group.
In 14-07-01 and 15-06-01, set up the trunk
Access Maps for PRI trunks.
Go to
B
Should extension
ring for incoming
calls on PRI trunk?
In 22-04-01, do not
assign extension
to PRI
trunk's Ring
Group.
In 22-04-01,
assign extension
to PRI trunk's Ring
Group.
No Yes
In 14-01-01,
assign names to
trunks to make
identification
easier.
For each extension in the Ring
Group, in 22-06-01, enter '1' for
each time mode when the
extension should ring.
In 35-02-15, enter '0' to
print Caller ID Number, “1” DID
Calling Number or ‘2’ Caller ID
Name.