NEC ELECTRA ELITE IPK II - Page 631

Electra Elite IPK II Document Revision 1
Music on Hold 2 - 609
Programming
Start
In 14-08-01,
enter 0.
Should a trunk use the
CPU, or the external
source connected to
the BGM or ACI port for
MOH?
In 10-03-01, confirm the
PGD(2)-U10 ADP to be
used for external music
source is recognized and
has type ‘9’ assigned.
CPU
ACI Port
BGM Port
Should the CPU
use the internal
or external
source?
In 14-08-01, enter 1.
In 10-04-01,
enter 0.
In 10-04-01,
enter 1.
In 10-04-03, adjust
the audio gain
setting (1~63).
In 14-08-01,
enter 2.
In 11-06-01, assign an
extension number to the ACI
port. Select a number outside
the normal extension number
range (e.g., 400).
In 33-02-01, assign ACI
software ports (1~96) to an
ACI Department Group
(1~16).
Is the MOH
gain
acceptable?
Stop
In 10-21-01, set the
external relay to 1.
In 14-08-02. enter the ACI
source port number
(1~96) for each trunk.
In 33-01-01, set the ACI
port to 1.
Internal
No
Note: Other ACI programming may be
necessary. Refer to Analog Communications
Interface (ACI) on page 2-31.
External
In 11-08-01. assign a pilot
number to the ACI group.