NEC ELECTRA ELITE IPK II - Page 803

Electra Elite IPK II Document Revision 1
Station Message Detail Recording 2 - 781
Programming
SMDR with a CPU Connection (Serial/USB/Ethernet)
Start
Which connection type
will be used to connect
the CPU for SMDR?
Connect an ethernet
cable from the CPU to
the PC to be used for
SMDR.
In 10-21-02, set the baud rate
(0=4800, 1-9600, 2=19200,
3=38400).
Connect a null modem cable from the CPU to
the PC to be used for SMDR.
(Refer to the Data and SMDR section in the
Electra Elite IPK II Hardware Manual for pin-out
details.)
Ethernet
In 10-20-01, define the
TCP port when
communicating to the
SMDR (external device
5).
Connect a USB cable
to the CPU and PC.
USB
The PC recognizes
the new hardware
and asks to install
the driver. Install
the CPU USB
driver.
In 35-01-01 set the
SMDR output to ‘3’ for
LAN.
In 35-01-01 set the SMDR
output to ‘1’ for COM port.
Go to
‘A’.
In 35-01-01 set the
SMDR output to ‘2’ for
CPUII USB.
Serial