Electra Elite IPK II Document Revision 1
Tandem Trunking (Unsupervised Conference) 2 - 817
With an analog trunk, the Continue/Disconnect code may work using DTMF sounds from
the opposite side trunk. With an ISDN trunk, Program 14-01-25 must be enabled to detect
the Continue/Disconnect code.
The Continue/Disconnect code is not accepted while dialing a trunk.
Continue/Disconnect codes will not work if all receivers are busy.
When used with the Networking feature, both systems must be programmed the same for
the Continue/Disconnect codes.
A trunk can be set up to automatically tandem trunk/forward to an outside telephone
number or Speed Dial – System/Group Dialing bin.
Other programmed options for incoming and outgoing calls can affect how calls are
handled. Refer to "Central Office Calls, Answering / Central Office Calls, Placing" and
check or program these options as needed.
DISA calls also use the same Continue/Disconnect codes.
Default Setting
Disabled
System Availability
Terminals
Multiline Terminals and Single Line Telephones
Required Component(s)
None
To Next Page
Loading...
