Document Revision 1 Electra Elite IPK II
2 - 818 Tandem Trunking (Unsupervised Conference)
Related Features
Call Forwarding, Off-Premise
Central Office Calls, Answering
Central Office Calls, Placing
Direct Inward System Access (DISA)
Programming
Tandem Trunking Method A - Tandem Trunking from Conference
10-07-01 Conversation Record Circuits
The number of circuits assigned as Conversation Record circuits limits the number of available
Conference circuits. Make sure there are circuits available for conference.
11-12-57 Service Code Setup (for Service Access) - Tandem Trunking/Unsupervised Conference
If the default service code (#8) for Tandem Trunking is not acceptable, change the code as
required.
14-01-04 Basic Trunk Data Setup - Transmit Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
14-01-05 Basic Trunk Data Setup - Receive Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
14-01-13 Basic Trunk Data Setup - Loop Supervision
For each trunk that should be able to participate in a tandem call, enter 1.
15-07-01 Programmable Function Keys
(Optional) Assign a function key for Transfer (code 06).
20-06-01 Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
20-07-11 Class of Service Options (Administrator Level) - Forced Trunk Disconnect
In an extension’s Class of Service, enter 1 to enable Forced Trunk Disconnect. This allows the
extension to disconnect an Unsupervised Conference in progress.
20-11-14 Class of Service Options (Hold/Transfer Service) - Trunk-to-Trunk Transfer
Disable (0) the Trunk-to-Trunk Transfer Restriction option.
To Next Page
Loading...
