NEC NP-PH3501QL - Page 52

26
1. Before Setting Up Your Projector
Input Selection
The power supply connection method is congured by the wiring to the input selection. The congurations are as follows.
C1 Connection
C2
Connection
AC power supply cable
• FortheACpowercable,useacableofthicknessasappropriatefortheinstallationcountryandmadeofcopperas
shown below.
• UsearoundtypeUL-listedsolderlessterminalforthesectionconnectedtothemainunit.Inaddition,whenclamping
this terminal with the cable, use an UL listed tool.
Compatible Cables and Solderless Terminals
The specications of the terminals for attaching the power cables are as follows.
Power supply terminal L, N Grounding terminal G
The size of the solderless terminal to use and the fastening torque of the screws varies depending on the type of
terminal block. Use the cable and solderless terminal that is suitable for the specic type of terminal block as shown
in the following table. This species the model name of the recommended solderless terminals. Use these parts or
equivalent parts. If you are unable to use the recommended solderless terminals, ensure that you use terminals of
the dimensions shown in the following diagram.