16
2. Projecting an Image (Basic Operation)
Standby Blinking Power On
Steady red light Blinking blue
light
Steady blue
light
❸ Turning on the Projector
1. Remove the lens cap.
2. Press the (POWER) button on the projector cabinet
or the POWER ON button on the remote control.
ThePOWERindicator will lightupinbluefromredand
thenstartblinking.Afterthat,theimagewillbeprojected
ontothescreen.
TIP:
• Whenthemessage“PROJECTORISLOCKED!ENTERYOUR
PASSWORD.” is displayed, it means that the [SECURITY]
featureisturnedon.(→ page 38)
• When the ECOmessage is displayed, it means that [ON] is
selectedfor[ECOMESSAGE].(→ page 110)
• PressingbuttonssuchaspowerbuttonandMENUbuttonwill
makesound.Toturnoffthebeepsound,select[OFF]for[BEEP]
fromthemenu.(→ page 121)
Afteryouturnonyourprojector,ensurethatthecomputer
orvideosourceisturnedon.
NOTE:Abluescreen(bluebackground)isdisplayedwhennosignal
isbeinginput(byfactorydefaultmenusettings).
(→page270)