18
2. Projecting an Image (Basic Operation)
❹ Selecting a Source
Selecting the computer or video source
NOTE:Turnonthecomputerorvideosourceequipmentconnectedtotheprojector.
DetectingtheSignalAutomatically
PresstheINPUTbuttonfor1secondorlonger.Theprojectorwillsearch
fortheavailableinputsourceanddisplayit.Theinputsourcewillchange
asfollows:
[HDBaseTModels]
HDMI1→HDMI2→DisplayPort→BNC→BNC(CV)→BNC(Y/C)→
COMUPTER→HDBaseT→HDMI1→…
[MMModels]
AutomaticallychecksforanyinputsignalintheorderHDMI1→HDMI
2→DisplayPort→BNC→BNC(CV)→BNC(Y/C)→COMPUTER→
USB-A.Theinputsignalwillbeprojectedwhenitisdetected.
• Pressitbrieytodisplaythe[INPUT]screen.
* ThisscreenbelongstoaHDBaseTmodel.
Pressthe▼/▲buttonstomatchthetargetinputterminalandthen
presstheENTERbuttontoswitchtheinput.Todeletethemenudisplay
inthe[INPUT]screen,presstheMENUorEXITbutton.
TIP:Ifnoinputsignalispresent,theinputwillbeskipped.
Using the Remote Control
Press any one of the 1/HDMI 1, 2/HDMI 2, 3/DisplayPort, 4/BNC, 5/
BNC(CV), 6/BNC(Y/C), 7/Computer, 8/HDBaseT*
1
, or 9/USB-A*
2
but-
tons.
*1 ForMMmodels,“8/Ethernet”willbeselectedandtheprojectorwillswitchto
theEthernet.
*2 HDBaseTmodelcannotbeused.